![integrand emx user manual integrand emx user manual](http://5b0988e595225.cdn.sohucs.com/images/20170923/caeb1395d64d4cc4974179144f229b5d.jpeg)
This adjusts the final level of the MONITOR bus. This controls the level of the effect sound which is returned from the built-in digital effect to the MONITOR bus. This graphic equalizer affects both the MONITOR bus signal that is output to the speakers and the line level signal which is output from the MONITOR jack (input/output panel 6). Moving a slider in the positive direction will boost, and in the negative direction will cut. Frequency response is flat when a slider is in the center position. You can use these sliders to reduce the level of frequency bands at which feedback easily occurs. To adjust the frequency response of the MONITOR bus signal, providing a maximum of ± 12 dB of cut/boost for each frequency band.
![integrand emx user manual integrand emx user manual](https://img.yumpu.com/13050934/1/500x640/users-manual-for-panda-ii-a-computer-code-for-calculating-.jpg)
This is a 7-band graphic equalizer that allows you This section allows you to adjust the tone and volume of the MONITOR bus, and specify the mix level of the built-in effect. When connecting a line level device to channels 1~4, or if the mic input is distorted, turn this switch on (the pressed-in position). This switch attenuates the input signal by 30 dB.
![integrand emx user manual integrand emx user manual](https://demo.vdocument.in/img/378x509/reader018/reader/2020011118/5a76fa197f8b9a93088d8800/r-2.jpg)
This adjusts the output level for each channel. This means that the amount of signal that is sent to the EFFECT bus will be affected not only by the setting of the effect control, but also by the setting of the level control. Note: The signal is sent to the EFFECT bus from a location after the level control ( 4) of each channel. The signal of the EFFECT bus passes through the EFFECT section and the built-in effect, and is sent to the external effect device connected to the EFFECT OUT jacks (input/output panel 3). This means that it will not be affected by the setting of the LEVEL control.įor each channel, this controls the amount of signal that is sent to the EFFECT bus. Note: The signal is sent to the MONITOR bus from a location before the level control ( 4) of each channel. The signal of the MONITOR bus is sent to the speakers connected to the POWER AMP 2 A/B jacks (only if the power amp select switch is in the MAIN+MONITOR position) and to the MONITOR jacks (input/output panel 6). Refer allįor each channel, this controls the amount of signal that is sent to the MONITOR bus. This product contains no user-serviceable parts. Do not open the case or attempt repairs or modifications yourself Strong physical shocks to the unit can cause damage. If heat release is inadequate, the unit will retain heat inside the unit, which may cause a fire. Remove the rear panel of the rack or open a vent hole. If you mount the unit in an audio rack, keep a space of 40 cm on the top panel, and a space of 15 cm to the side panel. Also, allow enough space between the unit and other devices. Also avoid locations which are subject to excessive dust accumulation or vibration which could cause mechanical damage.Īllow a distance of 30 cm between the unit and the wall so that heat generated from the unit will be released effectively. Keep the unit away from locations where it is likely to be exposed to high temperatures or humidity - such as near radiators, stoves, etc. Avoid excessive heat, humidity, dust and vibration Īs a conference PA system/installed sound system 10Īs a band PA.